aluminium trim
Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin
-
james911rs
- DDK above all
- Posts: 181
- Joined: Wed Nov 12, 2003 9:43 pm
- Location: Dorset
aluminium trim
Would anybody have, or know where i could get the piece of aluminium trim that sits on the bottom lip of the rear side window. I have two of them and neither of them are good enough to go back on my car, I am after the offside one. Thanks.
-
james911rs
- DDK above all
- Posts: 181
- Joined: Wed Nov 12, 2003 9:43 pm
- Location: Dorset
aluminium trim
I have just bought one of Peter, but it is not as good as i had hoped, it is much better than mine, but then has a nibble out of it where it is seen with the window shut. He said it was not perfect and i took a gamble. Oh well keep looking.
-
jtparr
- DDK 1st, 2nd and 3rd for me!
- Posts: 2367
- Joined: Mon May 24, 2004 10:54 pm
- Location: london/surrey
aluminium trim
hi james
I have a pair of these, as I have replaced my originals with new ones that I bought from Forest Fine. at around £100 each it was a bit steep but I thought as the cars having a full on restoration is would be worth it
there are no chunks missing just light scratches, with the most wear on the leading edge which folds over the door slam panel
I'm just about to go on vacation for a couple of weeks, if your interested I will take photos and email you when I return if you like. let me have your email address if its of interest
regards
Jonathan
I have a pair of these, as I have replaced my originals with new ones that I bought from Forest Fine. at around £100 each it was a bit steep but I thought as the cars having a full on restoration is would be worth it
there are no chunks missing just light scratches, with the most wear on the leading edge which folds over the door slam panel
I'm just about to go on vacation for a couple of weeks, if your interested I will take photos and email you when I return if you like. let me have your email address if its of interest
regards
Jonathan
-
Alan @ CanfordClassics
- Nurse, I think I need some assistance
- Posts: 4206
- Joined: Fri Nov 14, 2003 3:10 pm
- Location: Bournemouth
- Contact:
I am going to get some original sets, as well as door frames (for LWB cars) and door tops, re-polished and re-(bright) anodised. But this is a few weeks, maybe even a few months away.
Cheers
Alan
Cheers
Alan
http://www.canfordclassics.co.uk
Porsche Restoration & Sales
Porsche Restoration & Sales
-
Nick Moss
- Nurse, I think I need some assistance
- Posts: 9424
- Joined: Sat Nov 08, 2003 6:59 pm
- Location: East Sussex
- Contact:
-
james911rs
- DDK above all
- Posts: 181
- Joined: Wed Nov 12, 2003 9:43 pm
- Location: Dorset
aluminium trim
Would anyone know the part no. for both sides. Thought id try and get one from Germany but my German is not that good. Thanks
-
Nick Moss
- Nurse, I think I need some assistance
- Posts: 9424
- Joined: Sat Nov 08, 2003 6:59 pm
- Location: East Sussex
- Contact:

