Page 1 of 1
Underseals
Posted: Sat May 20, 2006 6:54 pm
by 1972_911t
As anyone come across a good underseal to match factory texture I have tried many different types but all just seem to give a thin covering not like the thick rubbery OE coverings used by manyfacturers.
Steve
Posted: Sat May 20, 2006 7:06 pm
by Lightweight_911
Wurth SKS, which is a water-based product, matches the Factory-applied original finish perfectly & readily accepts paint.
You will need a special gun to apply it.
Posted: Sat May 20, 2006 7:09 pm
by 1972_911t
Spray gun or schults gun?
Steve
Edit
Ok I think im dyslexic when I read Andys post for the first time I was sure he said you apply it with a "spray gun" hence the dumb ass question above.
Posted: Sun May 21, 2006 10:42 am
by davidppp
Neither, Steve.
Wurth do a special gun..
Kind regards
David
Posted: Sun May 21, 2006 11:54 am
by 1972_911t
Right! Where is the best place in Uk to get wurth products? Also is it a good idea to use water based sealants? couldnt this not lead to water being trapped in the seams or dose it require and under coat sealant first?
Thanks Steve
Posted: Sun May 21, 2006 12:28 pm
by davidppp
Hello, Steve.
This should help:
http://www.wurth.co.uk/contact.php
You are right, its a good idea to purt a nice thick coat or two of high-zinc primer under it..
Kind regards
David