Underseals

1972_911t · Post by **1972_911t** » Sat May 20, 2006 6:54 pm

As anyone come across a good underseal to match factory texture I have tried many different types but all just seem to give a thin covering not like the thick rubbery OE coverings used by manyfacturers.

Steve

Lightweight_911 · Post by **Lightweight_911** » Sat May 20, 2006 7:06 pm

Wurth SKS, which is a water-based product, matches the Factory-applied original finish perfectly & readily accepts paint.

You will need a special gun to apply it.

1972_911t · Post by **1972_911t** » Sat May 20, 2006 7:09 pm

Spray gun or schults gun?

Steve

Edit

Ok I think im dyslexic when I read Andys post for the first time I was sure he said you apply it with a "spray gun" hence the dumb ass question above.

davidppp · Post by **davidppp** » Sun May 21, 2006 10:42 am

Neither, Steve.

Wurth do a special gun..

Kind regards
David

1972_911t · Post by **1972_911t** » Sun May 21, 2006 11:54 am

Right! Where is the best place in Uk to get wurth products? Also is it a good idea to use water based sealants? couldnt this not lead to water being trapped in the seams or dose it require and under coat sealant first?

Thanks Steve

davidppp · Post by **davidppp** » Sun May 21, 2006 12:28 pm

Hello, Steve.

This should help:
http://www.wurth.co.uk/contact.php

You are right, its a good idea to purt a nice thick coat or two of high-zinc primer under it..

Kind regards
David