Page 1 of 1
Weber throttle linkage parts
Posted: Sun Feb 21, 2021 11:18 am
by MikeB
One of my Rod Ends on my IDAs has lost its internal spring clip, does anyone have a spare or know where they can be obtained? I have looked on the Webcon and they don’t seem to be listed.
It’s the left hand threaded one I need
Sent from my iPhone using Tapatalk
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 1:56 pm
by Lightweight_911
.
Not the same as the originals but if you don't have any luck elsewhere:
https://www.ebay.co.uk/itm/M5-BALLJOINT ... Sw9Xhc8VPI
.
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 2:59 pm
by Nine One One
Can you not just put a washer with a small hole drilled in it, bend down the flat area on one side, and secure it between the actual socket and the adjustment nut?
Might be a bit more secure as well.
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 3:15 pm
by MikeB
Unfortunately, "Does not ship to Northern Ireland" appears when I went to look at it, all part of this Irish Sea "border" fiasco.
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 3:27 pm
by TimB
Mike
If you can PM your email address I will send a couple of photos (never sorted out hosting photos to be able to post them on here) of miscellaneous Weber parts I have so you can see if I have anything that would help.
Regards
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 4:49 pm
by 911hillclimber
Mike, I have what you need in front of me. Not new, but very usable.
pm your address and I'll post it to you.
Graham.
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 9:02 pm
by 911hillclimber
Job done Mike.
Yhpm.
Re: Weber throttle linkage parts
Posted: Sun Feb 21, 2021 9:10 pm
by neilbardsley
If those don't work the late Chris F helped me finding linkage for my IDF's
You will need M5 joints.
The housings are specified as DIN 71805 and I can't find a supply in the UK for just housings with a LH Thread but the guys below do have complete units.
Regards
Chris
https://www.berger-tools.co.uk/Universa ... nc_Plated/
Sent from my Redmi 7 using Tapatalk
