Weber throttle linkage parts

[MikeB]

One of my Rod Ends on my IDAs has lost its internal spring clip, does anyone have a spare or know where they can be obtained? I have looked on the Webcon and they don’t seem to be listed.

It’s the left hand threaded one I need




Sent from my iPhone using Tapatalk

[Lightweight_911]

.

Not the same as the originals but if you don't have any luck elsewhere:

https://www.ebay.co.uk/itm/M5-BALLJOINT ... Sw9Xhc8VPI

.

[Nine One One]

Can you not just put a washer with a small hole drilled in it, bend down the flat area on one side, and secure it between the actual socket and the adjustment nut?
Might be a bit more secure as well.

[MikeB]

.

Not the same as the originals but if you don't have any luck elsewhere:

https://www.ebay.co.uk/itm/M5-BALLJOINT ... Sw9Xhc8VPI

.

Unfortunately, "Does not ship to Northern Ireland" appears when I went to look at it, all part of this Irish Sea "border" fiasco.

[TimB]

Mike

If you can PM your email address I will send a couple of photos (never sorted out hosting photos to be able to post them on here) of miscellaneous Weber parts I have so you can see if I have anything that would help.

Regards

[911hillclimber]

Mike, I have what you need in front of me. Not new, but very usable.
pm your address and I'll post it to you.
Graham.

[911hillclimber]

Job done Mike.
Yhpm.

[neilbardsley]

If those don't work the late Chris F helped me finding linkage for my IDF's

You will need M5 joints.

The housings are specified as DIN 71805 and I can't find a supply in the UK for just housings with a LH Thread but the guys below do have complete units.

Regards

Chris

https://www.berger-tools.co.uk/Universa ... nc_Plated/

Sent from my Redmi 7 using Tapatalk