Page 1 of 1
Five ribs ?
Posted: Sun Sep 13, 2009 8:28 pm
by Dakota
Hi All
I am after some five rib front inner wing closing panels for a '57 A , Restoration design list them but my supplier here , Mr Bray , does not stock them and while I'm at it does anyone do a repair section to repair the area around the torsion housing up to the rear bump stop for a 356, thanks Bill.
Posted: Sun Sep 13, 2009 9:42 pm
by Graham
Have you spoken to Mark because Im sure I saw some there on the racking last week!
repair sections
Posted: Mon Sep 14, 2009 10:23 am
by john fletcher
Bill,
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
repair sections
Posted: Mon Sep 14, 2009 10:23 am
by john fletcher
Bill,
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
repair panels
Posted: Mon Sep 14, 2009 10:26 am
by john fletcher
Forgot to add that I think Julian at KK has the correct 5 rib closing panels.
JF
Posted: Mon Sep 14, 2009 11:00 am
by cubist
He does...
Posted: Mon Sep 14, 2009 11:17 am
by roy mawbey
I wouldn't wait too long before you go to KK. I notice on the Stoddard site the early "A" 5 rib panels are now no longer available.
I see KK are the agents for Simonsen in Denmark. If you look on
www.simonsen-356.dk site you will see a great photolayout in one shot of all the steel structural items they make. If you click the union jack you will get a description of items.
I have seen torsion area cappings before just not sure where.
It would seem Simonsen produce all the press tooling for these panels and are always looking to make more new additions. I reckon KK will be able to advise you. The products look good.
Roy
Posted: Mon Sep 14, 2009 6:02 pm
by cubist
504.079.XX