Hi All
I am after some five rib front inner wing closing panels for a '57 A , Restoration design list them but my supplier here , Mr Bray , does not stock them and while I'm at it does anyone do a repair section to repair the area around the torsion housing up to the rear bump stop for a 356, thanks Bill.
Five ribs ?
-
Dakota
- DDK forever
- Posts: 586
- Joined: Thu Oct 25, 2007 10:46 pm
- Location: SE London under a rusty car
Five ribs ?
I am a person of simple pleasures so if you don't have any simple pleasures to offer me, beer, pizza or Porsche bits etc kindly leave me be, XX.
-
Graham
- DDK forever
- Posts: 561
- Joined: Sun Aug 01, 2004 12:56 am
- Location: Northern tip of dartmoors rocky wilderness
-
john fletcher
- DDK Fanatic
- Posts: 77
- Joined: Sat Aug 23, 2008 9:37 am
repair sections
Bill,
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
-
john fletcher
- DDK Fanatic
- Posts: 77
- Joined: Sat Aug 23, 2008 9:37 am
repair sections
Bill,
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
I noticed some rear repair sections on R.Bray's site which may be what you need. They are shown at the bottom of the new parts listing.
John
-
john fletcher
- DDK Fanatic
- Posts: 77
- Joined: Sat Aug 23, 2008 9:37 am
repair panels
Forgot to add that I think Julian at KK has the correct 5 rib closing panels.
JF
JF
-
roy mawbey
- Put a fork in me, I'm done!
- Posts: 1872
- Joined: Thu Dec 25, 2008 2:28 pm
- Location: sunny sussex
I wouldn't wait too long before you go to KK. I notice on the Stoddard site the early "A" 5 rib panels are now no longer available.
I see KK are the agents for Simonsen in Denmark. If you look on www.simonsen-356.dk site you will see a great photolayout in one shot of all the steel structural items they make. If you click the union jack you will get a description of items.
I have seen torsion area cappings before just not sure where.
It would seem Simonsen produce all the press tooling for these panels and are always looking to make more new additions. I reckon KK will be able to advise you. The products look good.
Roy
I see KK are the agents for Simonsen in Denmark. If you look on www.simonsen-356.dk site you will see a great photolayout in one shot of all the steel structural items they make. If you click the union jack you will get a description of items.
I have seen torsion area cappings before just not sure where.
It would seem Simonsen produce all the press tooling for these panels and are always looking to make more new additions. I reckon KK will be able to advise you. The products look good.
Roy
RHD 356A coupe super 75 106954
