356 Exhausts
-
- Put a fork in me, I'm done!
- Posts: 1816
- Joined: Thu Apr 24, 2008 7:41 pm
- Location: Worcestershire
- Contact:
356 Exhausts
Am 1 month/1500 miles into my new daily driver, a '61 356B T5 and it's just blown a hole in the 4-2-1 side exit exhaust. The valance panel has no notches and there is no bumper, so stock is out of the question and probably unsuitable for the (allegedly) warmed up motor. Anyway I like the look and sound of what I have. Does anyone know whether a 912 system will fit, if I can get a replacement one over here and what the alternatives are? I'd also appreciate views on noise (I like quiet!) and performance results (I like power!)
Winston
'61 356 BT5 & a lot of broken chain driven stuff
'61 356 BT5 & a lot of broken chain driven stuff
- Nige
- Nurse, I think I need some assistance
- Posts: 6604
- Joined: Wed Nov 26, 2003 9:11 pm
- Location: Denby, Derbyshire
OK, I know I bang on about it, but you could try Turbo Thomas, he's in Redditch so not far from you. Works in stainless and will make a system to suit your requirement. He works on alot of Porsche exhaust and likes a challenge.
http://www.turbothomas.com/
http://www.turbothomas.com/
-
- Put a fork in me, I'm done!
- Posts: 1816
- Joined: Thu Apr 24, 2008 7:41 pm
- Location: Worcestershire
- Contact:
356 Exhausts
Thanks, I've just tried them but too late for a Friday! Will try again Tues. Does s tainless make it noisier?
Winston
'61 356 BT5 & a lot of broken chain driven stuff
'61 356 BT5 & a lot of broken chain driven stuff