Tail-shifter end-cone casting, PLEASE.

swapped · Post by **swapped** » Mon Mar 17, 2008 10:31 am

Hi,

I find myself needing one of these for my 901 tail shift gearbox in my 914.

The picture (modified from one on 914world) shows a side shifter (but shows the correct part of the case casting - the tail cone, complete with the ears that hold the rear mounts), and the red line is where the crack is on mine, which you don't need to know, except to illustrate that I need a new casting.

I'm in Chester.

Thanks.

middlefour1 · Post by **middlefour1** » Mon Mar 17, 2008 10:57 am

Did'nt think you would be wearing sandels in Chester this time of year....

Good luck with the search. Ben, negawsklov on here, was breaking a car a while back.

swapped · Post by **swapped** » Mon Mar 17, 2008 11:08 am

middlefour1 wrote:Did'nt think you would be wearing sandels in Chester this time of year....

Good luck with the search. Ben, negawsklov on here, was breaking a car a while back.

Not my toes (not my gearbox, either), and not taken in Chester - pinched from 914world.

Thanks for the tip.

fourteener · Post by **fourteener** » Mon Mar 17, 2008 12:45 pm

Carl, you don't need to pretend or apologize to us about being open-toed. I'd be worried if you had socks with sandels.

swapped · Post by **swapped** » Wed Mar 19, 2008 9:03 pm

Now sourced a replacement - and through a DDKer

Thanks.