Bonnet badge fitting

jamie · Post by **jamie** » Wed Sep 20, 2006 10:28 am

Firstly, I will apologise for lowering the intellectual tone of this forum with this pretty daft question...

I have just bought a replacement badge kit for the bonnet of my new T and the rubber backing does not fit around the badge properly. It is too small. Is there some sort of technique to get it to fit?

craig001 · Post by **craig001** » Wed Sep 20, 2006 11:59 am

the usual trick for ruuber that is too small is heat it in a cup of very hot water, makes it much softer and stretchier, try that...

Dyno Soar · Post by **Dyno Soar** » Wed Sep 20, 2006 1:04 pm

Yes that normal... get the rubber warmed up and stretch that sucker round the emblem.

When you screw it down the it will stick in place no worries.

jamie · Post by **jamie** » Wed Sep 20, 2006 2:50 pm

Cheers guys - worked a treat!