Sourcing Weber IDA fuel inlet fibre washers

MdR · Post by **MdR** » Thu Sep 07, 2006 4:24 pm

As I don't really need a full carb rebuild kit, where can I get just the fibre(?) washers that seal the banjo unions from?

roger · Post by **roger** » Thu Sep 07, 2006 4:51 pm

Martin

I've got a bag full of Weber washer/gaskets. Can you give me some dimensions and I'll see what the garage can yield!

MdR · Post by **MdR** » Thu Sep 07, 2006 5:27 pm

Thanks Roger.
Next question - to save me disturbing my already weeping 40IDA3C fuel inlet banjos can anyone tell Roger the sizes I need?!?

Gary71 · Post by **Gary71** » Thu Sep 07, 2006 5:30 pm

I've also got a few. Halfords do them if you get really stuck!

Gilbert '71 T · Post by **Gilbert '71 T** » Thu Sep 07, 2006 7:19 pm

I had the same problem once and got some from my local motor factors for my old Zeniths

roger · Post by **roger** » Thu Sep 07, 2006 10:55 pm

Martin

I'm afraid the memory is playing tricks - got just one fibre washer and stacks of gaskets - sorry

Alan @ CanfordClassics · Fri Sep 08, 2006 12:05 am

I have some, I prefer to use copper ones there so have some fibre ones if needed.

MdR · Post by **MdR** » Mon Sep 11, 2006 5:29 pm

Thanks one and all.
Alan, can I buy your fibre ones?

Alan @ CanfordClassics · Mon Sep 11, 2006 5:46 pm

Hi Martin,

No need to buy them, just send me your address and I will forward some.

Cheers

Alan

MdR · Post by **MdR** » Tue Sep 12, 2006 1:54 pm

Yay! Thanks Alan. I'll buy you a pint somewhen.

Alan @ CanfordClassics · Tue Sep 12, 2006 7:39 pm

hmmm and I love beer, in fact I am on my second now

Airhead · Post by **Airhead** » Fri Sep 15, 2006 8:27 am

I been looking for some of these too. Perhaps a few more than required but Frost do them in both Metric and Imperial.....here's the page in their catalogue