Front inner wing top

impmad2000 · Post by **impmad2000** » Wed May 31, 2006 8:37 am

Does anyone know if you can get a repair panel for the inner wing top ?

Tim

davidppp · Post by **davidppp** » Wed May 31, 2006 8:51 am

I have never seen one, Tim.

Its quite a simple bit of tin to beat by hand from some 18G zincote..virtually undetectable when welded and beaten..

Kind regards
David

1972_911t · Post by **1972_911t** » Wed May 31, 2006 9:15 am

Alternatly get that section cut from a car in the reakers.

Steve

Barry · Post by **Barry** » Wed May 31, 2006 7:38 pm

Tim, if you have no joy, I'm sure Jonathan wouldn't mind me copying his one (here at the moment): I would imagine I could get it pretty close.

P.M. me if of any use: there's a good chance I'll see Ian D. before long so possible courier?

impmad2000 · Post by **impmad2000** » Thu Jun 01, 2006 7:23 am

Barry wrote:Tim, if you have no joy, I'm sure Jonathan wouldn't mind me copying his one

That would be great if you could

Cheers
Tim

Barry · Post by **Barry** » Thu Jun 01, 2006 9:26 pm

No problem, Tim: I'll try to deal with it over the next week or so, if that's O.K.?

If you need it short term, I could always bung it in the post, if not I'll sent it via 'DonkinForce 48hr Delivery'

Perhaps you could let me know just how far forward and down the repair panel needs to be?

impmad2000 · Post by **impmad2000** » Fri Jun 02, 2006 7:33 am

Cheers Barry, I'm in no rush. I'll let you know details.
Tim

Ian Donkin · Post by **Ian Donkin** » Sun Jun 04, 2006 6:56 pm

DonkinForce here and still alive!

Happy to oblige on this one at some point and I could pick up those two CDI boxes whilst I'm about it too...

I'll be back into usual circulation once I get a few minor 'lifestyle changes' concluded - and before you ask Cubicle no, I'm not having a sex change!