Hi all
Does anyone have any of the following to fit my 911/01 gearbox
Diff side cover
Input shaft
1st /reverse shifter
Clutch cable and nipple etc
Thanks Matthew
911/01 gearbox parts .side cover etc etc
Moderator: Miggs
-
tangerineT
- DDK forever
- Posts: 537
- Joined: Wed Feb 06, 2013 3:17 pm
- Location: near lincoln north Lincolnshire
911/01 gearbox parts .side cover etc etc
Last edited by tangerineT on Thu Sep 05, 2024 10:32 am, edited 3 times in total.
-
stretch
- Me and DDK sitting in a tree! KISSING
- Posts: 2891
- Joined: Thu May 21, 2009 2:54 pm
- Location: Kent
Re: 911/01 gearbox parts .clutch fork side cover etc etc
Hi Matthew. Do you mean this part.? https://www.ebay.co.uk/itm/274636045187 If so it's mine on ebay. Send me a message if it's correct.
70T barn find...... to ST.
1998 C2 996 Kettle
1998 C2 996 Kettle
-
Mike911scrs
- I luv DDK!
- Posts: 817
- Joined: Fri Mar 31, 2006 10:54 am
- Location: Kendal CUMBRIA
Re: 911/01 gearbox parts .clutch fork side cover etc etc
HI Matthew
Diff side cover, is that the Mag case cover with the support for the clutch cable, as 2.2 engine car
Clutch fork, which release bearing is it for, push or pull clutch
Input shaft, what ratio 2nd gear is the input shaft, "F", "G", "GA", or ?
Reverse gear , I take it the gear is missing that is in the end case and MATCHED to 1st gear is missing, I have a set of Std "A" ratio 1st gear set
regards mike
Diff side cover, is that the Mag case cover with the support for the clutch cable, as 2.2 engine car
Clutch fork, which release bearing is it for, push or pull clutch
Input shaft, what ratio 2nd gear is the input shaft, "F", "G", "GA", or ?
Reverse gear , I take it the gear is missing that is in the end case and MATCHED to 1st gear is missing, I have a set of Std "A" ratio 1st gear set
regards mike