Hello
Cannot get back pulley which goes onto the dynamo spindle square on. Wobbles about with shims needed to bring pulley back away from dynamo case. Am I missing something?
Thank you
912 Fan Pulley
-
adrianscott
- DDK Seasoned Poster
- Posts: 37
- Joined: Wed Mar 28, 2018 5:29 pm
912 Fan Pulley
You do not have the required permissions to view the files attached to this post.
-
Timo
- Put a fork in me, I'm done!
- Posts: 1664
- Joined: Wed May 16, 2007 9:52 pm
- Location: Shropshire
Re: 912 Fan Pulley
Adrian, in your second pic it looks close at the top and gappy at the bottom, is it just a case of it not tightening up squarely? I tend to tighten mine without the pulley locked initially which allows the pulley wheel to rotate a little as you go which allows it to go on squarely, I then lock the pulley and torque up the last bit.
-
wildtexas
- DDK forever
- Posts: 501
- Joined: Thu Apr 20, 2006 1:10 am
- Location: N. Ireland
Re: 912 Fan Pulley
Also your belt is riding low. How many shims do you have and where are they?
Can you tell.us the dimensions of the belt?
Can you tell.us the dimensions of the belt?
-
neilbardsley
- Nurse, I think I need some assistance
- Posts: 8621
- Joined: Mon Apr 16, 2012 4:31 pm
Re: 912 Fan Pulley
I think I might have 1 shim between the half and generator
Sent from my M2004J19C using Tapatalk
Sent from my M2004J19C using Tapatalk
“A REMINDER. I would be grateful if those members who have borrowed bits from me in emergencies (e.g starter motor, oil cooler, etc) would return them and/or contact me”. – Chris Turner RIP
-
adrianscott
- DDK Seasoned Poster
- Posts: 37
- Joined: Wed Mar 28, 2018 5:29 pm
Re: 912 Fan Pulley
Thank you all. Parts are worn too.