The one remaining (possibly!) original panel was dipped (and then I repaired it some time back). It was fine until it got a little flash rust in places when it rained during trailer loading on the way to Barry’s.
I started to clean it up, got bored and took it to a local paint shop where they blasted it for £25 and a two hour turn around! Sorted.
Quickly masked up and a coat of epoxy on the inside, with most of the dust in my garage by the look of it. Doesn’t matter as it will be getting a coat of Raptor before it goes on.
Next up was prepping the new OE wing for the same paint treatment. But needed to straighten out the flange first as it had pressing ripples and varied in shape as it went round.
Inside of the car is now finished. Bit of stonechip over the rear shelf/seats to make it resistant to a bit of water and add a bit of damping.... not sure it does anything for that though!
Back to the front and some prep of the luggage bay before another coat:
Came out ok, but gun pressure spiked and dumped a load of paint on the back wall. Guess it was partially blocked, not anymore!
Then the other front wing into epoxy (less dust this time!) and that’s enough for today.
Raptor inside the wings next then finally I can get the panels back on!
