Washer bottle attechment

rft218 · Post by **rft218** » Thu Dec 03, 2020 1:44 pm

Hi All,

I am a bit puzzled by the washer bottle attachment. At the top it goes through the hole in the slam panel with a big grommet. At the bottom there is a piece of metal which the bottom of the bottle slides into. There is a square hole in the section on the bottom of the bottle that fits into the metal in the car. It feels like it needs a bolt or some kind of special screw through it to stop it moving side to side, but cant see anything on the PET diagrams

Does anyone have any ideas on how it is fixed?

Thanks

Roger

Berny · Post by **Berny** » Thu Dec 03, 2020 2:10 pm

As far as I know it just clips in!

911hillclimber · Post by **911hillclimber** » Thu Dec 03, 2020 3:09 pm

^^Correct, quite heavy when full of water too.

hot66 · Post by **hot66** » Thu Dec 03, 2020 7:09 pm

As above , clips in on my car

rft218 · Post by **rft218** » Fri Dec 04, 2020 9:55 am

Thanks all, thats great - just thought the square hole looked like it wanted something in it. Its pretty firm and with water it wont go anywhere!

911hillclimber · Post by **911hillclimber** » Fri Dec 04, 2020 3:55 pm

Depends on how fast you go round bends!

Good fun testing.

rft218 · Post by **rft218** » Mon Dec 07, 2020 8:38 am

looking forward to it, but still some way off testing

DDK - Die Deutschen Klassiker

Washer bottle attechment

Washer bottle attechment

Re: Washer bottle attechment

Re: Washer bottle attechment

Re: Washer bottle attechment

Re: Washer bottle attechment

Re: Washer bottle attechment

Re: Washer bottle attechment