Touching in interior black metalwork

Silver911SC · Post by **Silver911SC** » Sun Jun 07, 2020 4:46 pm

Hi all

I have a few small chips to various bits of metalwork in the car (eg seat runners and seat hinges). I’m not looking to do a full restoration at this point in time, so I don’t want to either replace or take out and respray the entire parts. Does anyone have any recommendations for a good touch up paint/pen that would work well for touching in the chips?

I’ve attached a photo of one of the pieces I want to tidy up. I assume it would be a satin type rathe than fully Matt or gloss. Do you think something like this would be right, or any other suggestions greatly appreciated.

https://rover.ebay.co.uk/rover/0/0/99?l ... 2327135648

Phill · Post by **Phill** » Sun Jun 07, 2020 8:23 pm

Get a tin of satin black spray paint, spray some into the lid, touch up with paint brush.

jury · Post by **jury** » Mon Jun 08, 2020 1:05 am

Rustoleum satin black works well.....Old school Oil based enamel

Chris

911hillclimber · Post by **911hillclimber** » Mon Jun 08, 2020 8:10 am

I use Hammerite SMOOTH satin black.

It has a lot of solids in it and has some 'body' to level to the chipped satin original. Dries quite quickly but slower than most.

inaglasshouse · Post by **inaglasshouse** » Mon Jun 08, 2020 8:37 am

That's patina. Leave it.
Restoration is destruction!

DDK - Die Deutschen Klassiker

Touching in interior black metalwork

Touching in interior black metalwork

Re: Touching in interior black metalwork

Re: Touching in interior black metalwork

Re: Touching in interior black metalwork

Re: Touching in interior black metalwork