Bosch O2 sensor .. changing the connector to deutsch

[hot66]

Slightly odd onbe .. but does anyone know how to remove the original bosch connector from an O2 sensor & replace it with a deutsch connector ?

Bosch LSU 4.2 sensor with deusch connector

[Bruce M]

You'll need to cut off the terminal pins and crimp on the new ones with a decent crimping tool.

Quick google got me this for the pin out, if that helps

http://www.daytona-sensors.com/download/WEGO_Sensor.pdf

[smallspeed]

If you need a deutsch drop me a pm - I have a SHED load of them..

[hot66]

You'll need to cut off the terminal pins and crimp on the new ones with a decent crimping tool.

Quick google got me this for the pin out, if that helps

http://www.daytona-sensors.com/download/WEGO_Sensor.pdf

Ironically I'm replacing one of my bosch o2 sensors for my wego afr meter.

Probabally would have been easier to have just bought a new sensor direct from them with the deutsch fitting already in place.

So, I need new pins to crimp on.

Ben , do you have the pins as well as the deutsch fitting ? ( I might be able to reuse my current fitting ? )

[Bruce M]

You can usually reuse the fitting with new pins.

[smallspeed]

I've got crisps but they are tubular ones and the tool is mega bucks.. I can prob get you some "production" crimps but will have to check.

I have a ton of sockets / plugs and wedges

I do have loads of pre crimped bits of wire so can let you have a bunch of those if you are happy to solder them onto then ends of your wires. I can supply some glue lined shrinkwrap to help strain relief.. or feel free to post it to me and I can crimp with our £500 tool at work and post it back

[smallspeed]

Crimps not crisps

[smallspeed]

Sorry just read your post properly.. if you already have a deutsch connector, pull the wedge out of the middle, then you can pop the pins out and re use the housing.. if you're not sure post a pic of the connector you have and ill explain how

I can get you some pins just let me know how many and whether m or f