66 spline size

[delkel]

Hi 912ers
Firstly , great show of 12s at Stanford hall yesterday , hopefully have mine there next year !!!
Question, looking for a spare steering wheel for the 12 ! Not sure on the spline size for it! Is it just the number of teeth or diameter also?
Would appreciate any info .

Thanks

David

[SeanP]

David

It's the same size as 356c and early 911. Moto lita have a boss as well as momo.
Regards

Sean

[Lightweight_911]

If you're aiming to fit an aftermarket steering wheel you'll need the relevant Porsche-specific hub/boss for that steering wheel.

As Sean states, the hub you need will only fit 356B/C, '65-'74 911, '65-'69 912 & '70/'71 914/6 models.

[delkel]

Thanks for that info guys.

Is there a tooth count or a diameter of spline I need to know about?

I did look for you yesterday Sean to ask u about this but I saw that lovely motor had disappeared!!!!

[KS]

Thanks for that info guys.

Is there a tooth count or a diameter of spline I need to know about?

I did look for you yesterday Sean to ask u about this but I saw that lovely motor had disappeared!!!!

They're the same – if you're thinking about trying to find a wheel from an another make of car entirely, then the chances are pretty slim, except maybe a VW Beetle of a certain age....

[SeanP]

Thanks for that info guys.

Is there a tooth count or a diameter of spline I need to know about?

I did look for you yesterday Sean to ask u about this but I saw that lovely motor had disappeared!!!!

Dave

Sorry left early as the Mrs was full of woman flu. (apparently that is worse than man flu and curtails all fun. So i am told)

Remember its a ten foot car with your eyes closed

I have a moto lita hub down the garage and will measure it for you if you really want. I seem to remember 40 splines somewhere in my memory but let me check

[C3s]

I have a Mountney boss fitted to my 66 which will be not needed soon, hope it helps??

[delkel]

All helps
The hole pattern on the boss that would marry up with the actual wheel would be a good measure also.hole to hole across wheel. I know I am going on about this but I have seen a wheel I might purchase and it would be good to get the correct one.
I think spline number and diameter would be very helpful.
Shame i missed you Sean, hope your other half is feeling ok!
One 12 was pushed out !!!! Well pushed for a bump start!!!!

[C3s]

It's buried at work but know it has 6 holes on the outside flange to mount onto the wheel, hope this helps a bit more??

[Lightweight_911]

If it helps, the correct hub model numbers for your car are:

Momo - 0230, C230 or L230 (depending on age/depth of hub - all will fit)

Nardi - 0146

Moto Lita - F9