Hello. I wish to put the correct under seal on my 6 "rep". As used by the factory. What do I need to purchase and where from.
Thank you.
Black Jacking a 6.
Moderators: drummerboytom, MdR
-
carl
- DDK addict
- Posts: 109
- Joined: Wed Dec 12, 2007 7:44 pm
- Location: the ether
-
glovebox
- DDK slapper chatter
- Posts: 389
- Joined: Tue Jul 06, 2010 10:38 pm
- Location: Münster Germany
Black Jacking a 6.
Hi Carl, I'm sure some would call me a bit bias ! But I would say Glasurit 1109- stone chip product!! It's water Bourne so less stinky ! And was used back in the day on all Porsches at the factory!
However there is many good products out there now ! Just don't put any of them over bare steel or directly over an acid based primer ! Chemically it's wrong !!
I would suggest asking your friendly neighbourhood body shop to buy it for you! If you go direct to a refinish paint distributor you will not get the discount a body shop will get!
You maybe will get 10-20 percent ! They will get 50-60 or more !!
Good luck Mark.
However there is many good products out there now ! Just don't put any of them over bare steel or directly over an acid based primer ! Chemically it's wrong !!
I would suggest asking your friendly neighbourhood body shop to buy it for you! If you go direct to a refinish paint distributor you will not get the discount a body shop will get!
You maybe will get 10-20 percent ! They will get 50-60 or more !!
Good luck Mark.