Pipe Bending for tail pipe

Dyno Soar · Post by **Dyno Soar** » Mon Jun 06, 2005 1:45 pm

I am going to get an ali pipe about 30cm in length to act as my tail pipe. The thing is I will ne to bend it slightly to get it to exit in the right area under the RS bumper.

Is there anyway that I can DIY bend the pipe? Any tricks or will I have to go to find the right person to do it?

roger · Post by **roger** » Mon Jun 06, 2005 4:35 pm

Go to one of the better exhaust centres such as Stapletons as they (used to) have pipe bending jigs and will probably do it for a drink.

Dyno Soar · Post by **Dyno Soar** » Mon Jun 06, 2005 4:52 pm

Thanks.. I'll try to look up my local Stapeltons.