Is it possible to machine a normal head to super spec?

Porsche 356 Virtual home

Moderators: 58A - 71E, Helen

Post Reply
58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Is it possible to machine a normal head to super spec?

Post by 58A - 71E »

Anyone know and what is entailed?

Had a quick read of the Harry Pellow book ABC and 912s and think the only difference is the intake ports - can anyone confirm and what the difference actually is? (1957.5- 1963 heads - the Late A early B heads)

Thanks
James

'58 356A 1600n
'71 911E 2,2


#0335
john fletcher
DDK Fanatic
Posts: 77
Joined: Sat Aug 23, 2008 9:37 am

heads

Post by john fletcher »

James,
They are the same. The higher compression was achieved with different pistons. Cam is also different.
John
58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Post by 58A - 71E »

Hi John
Pellow suggests oval intake became circular with Super head - and that manifolds are different diameter for fitting with Super Zeniths?
James

'58 356A 1600n
'71 911E 2,2


#0335
john fletcher
DDK Fanatic
Posts: 77
Joined: Sat Aug 23, 2008 9:37 am

heads

Post by john fletcher »

Hi James,
The Parts List just shows just one manifold for the Normal and Super but two Zeniths, PO3 for N and PO2 for S. Jets were also different but the main difference was the venturi increased from 24mm to 28mm.
However you can never be absolutely sure unless you have the parts on view.
John
cubist
The Fenland Feltcher
Posts: 4044
Joined: Wed Dec 03, 2003 12:48 pm

Post by cubist »

A bit of match-porting will go a long way to improving what you can get out of the std heads. You could go to the cost of machining for bigger valves?
C U B I S T - 1 1 1 5

'83 Triumph Acclaim - 3sp Auto (cat D)
Singer 3232 - Titanium bobbin, Autothread
'67 Gresham Flyer - Puncture, rear
Sherbet Lemons - 4oz, loose
Motorola - PG 2000, locked
Dakota
DDK forever
Posts: 586
Joined: Thu Oct 25, 2007 10:46 pm
Location: SE London under a rusty car

Post by Dakota »

Hi
as already stated I believe the heads are the same , the later ones have a pair of webs cast into the valve chest , I think your mild confusion is over the C inlet manifolds that flare out internally to mate up with the larger ports they used in the heads (this is the opposite to convention which has the inlet tract tapering down to the valve to keep the mixture speed up) The C and SC had the same port size and as for the inlet manifolds employed for C's to me they look the same as the earlier ones from the outside and I think they are the same castings. Super Zeniths have different jets and larger bore chokes but the basic carb is the same oh and weirdly unimogs used those Zeniths too..
I am a person of simple pleasures so if you don't have any simple pleasures to offer me, beer, pizza or Porsche bits etc kindly leave me be, XX.
Post Reply