Rubber for 7R Fuchs
Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin
-
julian911
- DDK Fanatic
- Posts: 93
- Joined: Tue Dec 11, 2007 8:46 am
- Location: London
Tape measure out. As it is a US car, 26" front, and 27" rear, floor to bottom of wheelarch going through centre of wheel. Is that tall? I was expecting US cars to be about an inch taller than a UK car, and so that makes a UK car 25" and 26" which sounds about right...
"Racing is life. Everything before or after is just waiting."
'87 Carrera
'58 Fiat 500
'59 Fiat 500
'87 Carrera
'58 Fiat 500
'59 Fiat 500
-
Lightweight_911
- Nurse, I think I need some assistance
- Posts: 18004
- Joined: Wed Nov 12, 2003 10:48 pm
- Location: Worcs/W Mids border
On level ground, the measurement fom the ground to the centre of the wheelarch (highest point) for a standard lwb car is:
25.5 in - front
25.0 in - rear
I don't know if the corresponding measurements for a swb are any different.
As far as I'm aware, there was no difference between US & ROW ride height until much later - after the introduction of the impact bumper models - I think ~ 1976.
25.5 in - front
25.0 in - rear
I don't know if the corresponding measurements for a swb are any different.
As far as I'm aware, there was no difference between US & ROW ride height until much later - after the introduction of the impact bumper models - I think ~ 1976.
Andy
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
-
mycar
- Nurse, I think I need some assistance
- Posts: 7490
- Joined: Sat Aug 04, 2007 3:05 pm
- Location: Harrow Gate.
- Contact:
Here`s some previous details of assorted ride hieghts
http://www.ddk-online.com/phpBB2/viewto ... ide+hieght
My SWB is 25.5 front 25.57 rear
Mike.
http://www.ddk-online.com/phpBB2/viewto ... ide+hieght
My SWB is 25.5 front 25.57 rear
Mike.
1959 S
http://tinyurl.com/3l95xmh
http://tinyurl.com/3l95xmh
-
500gls
- DDK addict
- Posts: 124
- Joined: Fri Apr 04, 2008 6:05 pm

