bits

pantswagen · Post by **pantswagen** » Fri Dec 07, 2007 3:29 am

930 for re build -chop in £160

type 4 van stock length performance doings - will swap for some shorty ones or £80

one as new 964 front disc -bought in error -cheaper than new££££ - or wapsies

pair of them there 965 disceroonies, skimmed from 32 to about 30 £100

centremount doings £20

csp pulley £30?
-4 44mm alloy trumperts £25??

swapsies

a better pic of those dooberies - i buyed them thinking i could cut them, -but i cant - will fit a 92 i think - i dunno though
will swap for some short ones

set of mint refurberished cup 2's 17's both 55et -will swapsies the rears for them helucyve 70 et;s

hughicol · Post by **hughicol** » Mon Dec 10, 2007 1:49 pm

Hi

The photo before the wheels seems to be a silencer but there is no reference to it. What vehicle is it for?

Dave

Nige · Post by **Nige** » Mon Dec 10, 2007 2:32 pm

looks like a twin quiet pack for a type IV, Bus maybe?

hughicol · Post by **hughicol** » Mon Dec 10, 2007 2:35 pm

Hi Nige

Was hoping it may be for a 914

Dave

Nige · Post by **Nige** » Mon Dec 10, 2007 3:05 pm

I'm sure with abit of jiggery pokery it could be made to fit, the J tubes are for a van says higher in the thread, they will be too short for a 914.

hughicol · Post by **hughicol** » Mon Dec 10, 2007 3:15 pm

Hi Nige

But the distance between the inlets to the silencers are different.

Dave

swapped · Post by **swapped** » Mon Dec 10, 2007 3:21 pm

hughicol wrote:But the distance between the inlets to the silencers are different.

Not by much, though.

It'll fit if you want it to.

912uk · Post by **912uk** » Mon Dec 10, 2007 4:51 pm

interested in the 4 44mm trumpets.

can you tell me the pcd of the two holes..?

pantswagen · Post by **pantswagen** » Mon Dec 10, 2007 11:42 pm

typically, i go and get some csp inlets at 55
-get the trumpets at 44mm
-decide i only want 40's
-then some 44's come up 4 sale
-hold fire for a ickle bit
-ps tehy are idf dell ones, well i think so

Dyno Soar · Post by **Dyno Soar** » Tue Dec 11, 2007 11:46 am

Is that pulley wheel for a T4 engine?

Will it fit onto a web cam?

Thanks

Nige · Post by **Nige** » Tue Dec 11, 2007 11:59 am

looks type iv to me Alam, three mounting holes, type i are just one big bolt. Why does it need to fit to a web cam? They are usually fitted to the crankshaft. Or do you intend to fit a webcam onto it for those dodgy internet performances you do?

hughicol · Post by **hughicol** » Tue Dec 11, 2007 12:02 pm

The centre hole looks rather big on the picture.

Dave

pantswagen · Post by **pantswagen** » Tue Dec 11, 2007 11:06 pm

its because its type 1 sized

-ie to be used on a type 4 with a dtm
-or cali doobery

DDK - Die Deutschen Klassiker

bits

bits

Bits

Bits

Bits

Re: Bits

typically

Bits

itssss