MFI X bar and linkages WANTED

veryporky · Post by **veryporky** » Sun Oct 07, 2007 8:17 pm

Dear all,

After a spare set of MFI linkages and X bar to anodise. If anybody has a set that has already been done sitting around so much the better......

johnM · Post by **johnM** » Sun Oct 07, 2007 9:34 pm

Hi Keith

the mfi links were made from mild steel so you can not anodise them, the ones that are available from Henry at supertech have mild steel sockets and aluminium anodised rods, I had to replace my cross bar and found that these were still available from Porsche, it may be helpful to look at this thread.

http://www.ddk-online.com/phpBB2/viewtopic.php?t=16879

Regards

Alan @ CanfordClassics · Mon Oct 08, 2007 8:26 am

If it helps and you need them quicker than buying direct I have a lot of the supertech products in stock.

Alan

butzsi · Post by **butzsi** » Mon Oct 08, 2007 7:58 pm

Keith,

I have crossbars that have been replated (Passivated zinc finish).Send me a pm if you would like one on exchange.

Regards..........Chris

johnM · Post by **johnM** » Mon Oct 08, 2007 8:20 pm

Hi There are a couple of differant types of MFI crossbar just make sure you get the correct one.

911 110 073 00

901 110 057 00

Regards

DDK - Die Deutschen Klassiker

MFI X bar and linkages WANTED

MFI X bar and linkages WANTED

MFI X Bar & Linkages