Hi there
I have passenger Recaro Idealsitz S that i'm planning to install, unfortunately one of the rails is damaged, does anyone have any ideas where i can get this repaired?
similar to this
thanks
Farrukh
Recaro Idealsitz S Seat refurb
Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin
-
- DDK 1st, 2nd and 3rd for me!
- Posts: 2066
- Joined: Wed Jun 23, 2004 9:47 pm
- Location: Nottinghamshire
Re: Recaro Idealsitz S Seat refurb
I think the proper answer is to heat, bend back and TIG weld, as I suspect it is fractured to have twisted so far.
As a DIY job, I would be inclined to heat and twist back to centre, and if breaks then clean up what is left and leave a gap. As it is the passenger side it simply means an extra spacing between locking positions - hardly a problem. Save the bit that broke off and get TIG welded when you find someone local with the kit/skills.
Lovely seats by the way!
As a DIY job, I would be inclined to heat and twist back to centre, and if breaks then clean up what is left and leave a gap. As it is the passenger side it simply means an extra spacing between locking positions - hardly a problem. Save the bit that broke off and get TIG welded when you find someone local with the kit/skills.
Lovely seats by the way!
93 964 C2
99 Boxster 2.5 > 2.7 hill climber
71 914/6 3.0 - gone
'You see Paul, hill climbing is like making love to a beautiful woman. You get your motor running, check your fluids, hang on tight and WHOA..30 seconds later it's all over!' Swiss Tony
99 Boxster 2.5 > 2.7 hill climber
71 914/6 3.0 - gone
'You see Paul, hill climbing is like making love to a beautiful woman. You get your motor running, check your fluids, hang on tight and WHOA..30 seconds later it's all over!' Swiss Tony
Re: Recaro Idealsitz S Seat refurb
Thanks, they are great seats but bloody heavy!