How easy is it to fit an 050 distributor? Is it idiot proof (if I'm gonna do it myself it probably has to be totally idiot proof!) or should I get someone who knows what they're doing to do it?
F
Fitting an 050 Distributor
Moderators: hot66, impmad2000, Nige
-
- Moderator
- Posts: 664
- Joined: Mon Nov 10, 2003 9:03 am
- Location: Berkshire
-
- Moderator
- Posts: 664
- Joined: Mon Nov 10, 2003 9:03 am
- Location: Berkshire
-
- DDK Seasoned Poster
- Posts: 29
- Joined: Thu Nov 13, 2003 9:32 am
- Location: Worthing, West Sussex
- Contact:
a cheap Gunsons timing light comes in handy for this - a bit of Tipex or white paint on the timing mark of the fan belt pulley (crankshaft)
and an idea of the timing setting (degrees before/after top dead centre TDC)
BUT....
at least to start with mark where your current distributor position is by a common point on both the old dissy and new dissy body - i.e the welding seams on the side of the body - mark where this is pointing on the engine with a small scrath or paint dab, and fit the new one in as nearly the same position as you can - then set the points gap (to set, take off the black cap and rotor arm, and ensure the cam profile is fully opening the points at their maximum opening (may need to engage second gear and give the car a shove forward until it is so -on level ground ) and adjust accordingly the gap so it just resists against the appropriate size of feeler guage (.40mm or .016inch) when you try and slide the feeler in and out between the points.
hope this helps
and an idea of the timing setting (degrees before/after top dead centre TDC)
BUT....
at least to start with mark where your current distributor position is by a common point on both the old dissy and new dissy body - i.e the welding seams on the side of the body - mark where this is pointing on the engine with a small scrath or paint dab, and fit the new one in as nearly the same position as you can - then set the points gap (to set, take off the black cap and rotor arm, and ensure the cam profile is fully opening the points at their maximum opening (may need to engage second gear and give the car a shove forward until it is so -on level ground ) and adjust accordingly the gap so it just resists against the appropriate size of feeler guage (.40mm or .016inch) when you try and slide the feeler in and out between the points.
hope this helps
Dimitri - 67 LHD 912 - get your metal out in the rain and use it - DDK No: 1129