Hi all, can anyone tell me the depth the flywheeel must be to except a 200mm VW clutch. I wish to get my 180mm flywheel machined out.
Dave Ren
vw clutch on 356 flywheel
vw clutch on 356 flywheel
Avoiding local so-called self proclaimed specialists.
-
- DDK Seasoned Poster
- Posts: 31
- Joined: Thu Mar 09, 2006 12:24 pm
- Location: Barton on Sea
200 mm VW clutch
Hi Dave
I had my flywheel machined recently to take a 200 mm clutch I also had the out side profile machined to match a super 90 which saves a bit of weight but not too much to loose torque.Claren tooling in Boscombe did the work for £70.
I will dig it out as I have not put this engine together yet and post the dimensions you need.
Cheers Nigel
I had my flywheel machined recently to take a 200 mm clutch I also had the out side profile machined to match a super 90 which saves a bit of weight but not too much to loose torque.Claren tooling in Boscombe did the work for £70.
I will dig it out as I have not put this engine together yet and post the dimensions you need.
Cheers Nigel
VW clutch 356 flywheel
Nigel thanks that would be great help.
Avoiding local so-called self proclaimed specialists.
-
- DDK Seasoned Poster
- Posts: 31
- Joined: Thu Mar 09, 2006 12:24 pm
- Location: Barton on Sea
vw clutch on 356 flywheel
Hi Dave
The dimensions you need are:
The outer ring depth for the cover plate = 4.5mm
From the bottom of the cover plate face above( i.e 4.5 mm down) to clutch running face=21.3mm
Hope this is OK let me know if you need any more info.
Best regards Nige
The dimensions you need are:
The outer ring depth for the cover plate = 4.5mm
From the bottom of the cover plate face above( i.e 4.5 mm down) to clutch running face=21.3mm
Hope this is OK let me know if you need any more info.
Best regards Nige
vw clutch on 356 flywheel
Nige, My kennedy pressure plate has a round piece in the centre on the finger spring bits that my old Sache pressure plate did not have. Do I have this removed? Also I have a C gear box, which throw bearing is best?
I have a measurement of 21.5 from Duane Spencer book?
Much thanks.
DRen
I have a measurement of 21.5 from Duane Spencer book?
Much thanks.
DRen
Avoiding local so-called self proclaimed specialists.
vw clutch on 356 flywheel
Right I have some more sizes:
outer ring to first surface 4mm
pressure plate surface to clutch surface 21mm
with 203mm diameter hole.
outer ring to first surface 4mm
pressure plate surface to clutch surface 21mm
with 203mm diameter hole.
Avoiding local so-called self proclaimed specialists.