964 cams

[PeterK]

While already suffering from way too much 'while I'm in there' with my engine, it would be remiss of me not to ask whether anyone has a decent set of 964 cams surplus to requirements.

Peter

[Berny]

I Have a a new left hand one on ebay at the moment!

[PeterK]

Thanks Bernie
Can't find that - just a table lamp version and a pair of 964 turbo cams in the USA

[chaos]

Hia,

I do have a pair of very good camshafts I was going to fit to a 3ltr

The rear drive has been removed so only good if fitting an earlier motor.

£500 for the pair.

Cheers Dave

[mean_in_green]

Pretty sure a pair popped up on ebay last week too.

[PeterK]

Simon / mean_n_green - I only saw 964 turbo cams this week.

Dave / Chaos - thanks.

All - I've been advised by someone who should know that 964 cams will give me the benefit of a couple of hundred extra revs at the top end. Staying with the SC cams will give me more torque down low. As my (3.2SS) SC is intended to be a daily driver, not a track tool, what say you learned folks ?

[corner shop]

https://rover.ebay.com/rover/0/0/0?mpre ... 4125642366

[DustyM]

964 cams are a good upgrade, although I'm not sure you will see much of a power increase over the SC cams they do make the engine feel more lively as they are not so linear in their power delivery, you will feel the engine come on cam as it passes 3000 - 3500 revs. It will certainly make the engine more fun.

[PeterK]

Great - thanks for the insight


Sent from my iPhone using Tapatalk

[classicgarage]

hi peterk , i have two sets of cams , one set is perfect and the other set is slightly worn , regards mervyn