Rear seat belt mounting points

philip_sloper · Post by **philip_sloper** » Mon Apr 14, 2008 7:03 pm

Are there any mounting points for a rear seatbelt already provided in a 1973 911?

I would like to install two point lap belts.

Gary71 · Post by **Gary71** » Mon Apr 14, 2008 7:09 pm

Yup, should be there, maybe under the carpet?

Luke · Post by **Luke** » Mon Apr 14, 2008 7:16 pm

There will be mountig points for lap belts only un the carpet, if you want inertia's you'll have to do some bodging yourself

philip_sloper · Post by **philip_sloper** » Mon Apr 14, 2008 8:34 pm

Thanks for the prompt answers, I'll have a look under the carpet.

Any idea where to get the belts from?

hot66 · Post by **hot66** » Mon Apr 14, 2008 8:56 pm

you don't need to lift / remove the carpets ... use a long needle / spike & use it to poke through the carpet until you find the threaded hole.

Alan @ CanfordClassics · Mon Apr 14, 2008 9:20 pm

To give you a rough idea where to poke... but if there were no belts there, there will be a plastic blanking plug which will need removing first.

and you could try here for the belts....

http://www.quickfitsbs.com/

HTH

Alan

willbrown · Post by **willbrown** » Thu Sep 03, 2009 3:47 pm

Can anyone tell me what size bolt fits the rear mounting points please?

smallspeed · Post by **smallspeed** » Thu Sep 03, 2009 3:56 pm

the mounting points look the same as a IB or later air cooled porsche and the replacement bolts for the rear of my 964 were only about £1 each from an OPC.. might be worth getting the correct bolts from them

they're not standard pitch (metric fine i think) and are around M16, plus being seatbelt bolts they're supposed to be 10.1 grade or higher i think?..

Mick Cliff · Post by **Mick Cliff** » Thu Sep 03, 2009 3:57 pm

willbrown wrote:Can anyone tell me what size bolt fits the rear mounting points please?

7/16ths UNF I think

willbrown · Post by **willbrown** » Thu Sep 03, 2009 4:00 pm

Thanks guys. OPC it is then.

Will

Gary71 · Post by **Gary71** » Thu Sep 03, 2009 4:10 pm

Mick Cliff wrote:
willbrown wrote:Can anyone tell me what size bolt fits the rear mounting points please?
7/16ths UNF I think

Definitely 7/16 UNF.

willbrown · Post by **willbrown** » Thu Sep 03, 2009 4:42 pm

Thanks, Gary