Page 1 of 1
Front inner wing top
Posted: Wed May 31, 2006 8:37 am
by impmad2000
Does anyone know if you can get a repair panel for the inner wing top ?
Tim
Posted: Wed May 31, 2006 8:51 am
by davidppp
I have never seen one, Tim.
Its quite a simple bit of tin to beat by hand from some 18G zincote..virtually undetectable when welded and beaten..
Kind regards
David
Posted: Wed May 31, 2006 9:15 am
by 1972_911t
Alternatly get that section cut from a car in the reakers.
Steve
Posted: Wed May 31, 2006 7:38 pm
by Barry
Tim, if you have no joy, I'm sure Jonathan wouldn't mind me copying his one (here at the moment): I would imagine I could get it pretty close.
P.M. me if of any use: there's a good chance I'll see Ian D. before long so possible courier?
Posted: Thu Jun 01, 2006 7:23 am
by impmad2000
Barry wrote:Tim, if you have no joy, I'm sure Jonathan wouldn't mind me copying his one
That would be great if you could
Cheers
Tim
Posted: Thu Jun 01, 2006 9:26 pm
by Barry
No problem, Tim: I'll try to deal with it over the next week or so, if that's O.K.?
If you need it short term, I could always bung it in the post, if not I'll sent it via 'DonkinForce 48hr Delivery'
Perhaps you could let me know just how far forward and down the repair panel needs to be?
Posted: Fri Jun 02, 2006 7:33 am
by impmad2000
Cheers Barry, I'm in no rush. I'll let you know details.
Tim
Posted: Sun Jun 04, 2006 6:56 pm
by Ian Donkin
DonkinForce here and still alive!
Happy to oblige on this one at some point and I could pick up those two CDI boxes whilst I'm about it too...
I'll be back into usual circulation once I get a few minor 'lifestyle changes' concluded - and before you ask Cubicle no, I'm not having a sex change!