Page 1 of 1
right then nick... this new gauge i brought Oil Pres/temp
Posted: Thu Jan 29, 2004 4:14 pm
by chickybok
ok... how do I plum this in to a 1966 912?
Do I need new senders etc??
anyone done this before?
David
Posted: Thu Jan 29, 2004 4:26 pm
by Nick Moss
I would guess that the existing temperature sender and wiring may work with the new gauge, but you may need to fit a sender to match the gauge. The pressure light will work off your exixting sender and wiring, but you will need a matching pressure sender.
Posted: Thu Jan 29, 2004 10:47 pm
by Alan @ CanfordClassics
You will need the correct temp sender David. Also, where do you intend on fitting the pressure sender on a 912 motor?
Alan
Posted: Thu Jan 29, 2004 10:58 pm
by 912uk
I too am going down this route I did buy from a company new gauges and sender units they were resonable priced to.
Sewell of leeds
0113 243 5101
The senders have a thread size of M14 x 1.5
the oil temp one for the 912 I ordered to match the gauge was a
323.801/004/030K
Now with this gauge do you just need to find the correct sender unit or do they have to match in some way. I would have though just the correct temp range. Which the above number is.
As for fitting I was going to plum in on the connector under the oil filter I can get the oil temp there but can't remember if I can add in a oil pressure sender? as well.
Oh also the guy I spoke to was Graham Park nice guy arrived Next Day.