DDK - Die Deutschen Klassiker

Pair Of T spec Rear Over Riders without rubbers - 75
40cm steering wheel dated feb 69 pretty nice condition with some patina - £125
Glove box light lense - £20
1x RHD H1 headlight lens in VGC original with raised "Bosch" script - bought as a spare - these must be pretty hard to find these days - £150
66mm T Crankshaft - came out of a running engine but I havent bothered to measure this yet, will do so for any interested party just let me know, looks a bit grimey but its just dust stuck to the coating of oil it has - £250
Im pretty sure this is an original 911 jack and handle - £75
MFI fuel pump mounting bracket for 69-71? cars when mounted near the steering rack - £75



Pair of Front Over Riders with Rubbers - Rubbers still have useable studs etc - SOLD
Pair of Rear Over Riders with Rubbers - One rubber has sheared its mounting studs - SOLD
2x MFI injectors - I bought these as good useable spares but I have never used them - SOLD
90% of a set of genuine main bearings, std size but missing the thrust bearings - SOLD
3x black chain ramps - SOLD
new bearings for intermediate shaft - SOLD
Original RHD undertray, these must be very hard to find these days as well - SOLD


I can supply more pictures of anything on request

Prices include shipping to UK - extra for abroad.

If paying via paypal I expect F&F or add 4% to cover the fees

Thanks

Neil

Can I have the bearings please and chain ramps, assuming they'll work on a 66mm crank?

Sent from my SM-S918B using Tapatalk

Neil
Hello could you please contact me on jan@rostek.fi (as I'm not yet allowed to send pm). I would like to buy the injectors from you if they are "correct" for a 2.4E?
R. Jan

RobFrost wrote: ↑Tue Dec 03, 2024 6:20 am Can I have the bearings please and chain ramps, assuming they'll work on a 66mm crank?

Sent from my SM-S918B using Tapatalk

Yes ill PM you

janne1 wrote: ↑Tue Dec 03, 2024 7:57 am Neil
Hello could you please contact me on jan@rostek.fi (as I'm not yet allowed to send pm). I would like to buy the injectors from you if they are "correct" for a 2.4E?
R. Jan

Yes, all MFI injectors were the same 2.0/2.2/2.4 E/S.

I will email you

Hi Neil. I’d be interested in the under tray if its solid i.e. not fiberglass and filler under thick paint. I might also be interested in the two over riders with rubbers if you could send me a few better pictures to my email Richard@Bodytektaunton.co.uk

Many thanks Richard

RichardBTek wrote: ↑Wed Dec 04, 2024 9:24 am Hi Neil. I’d be interested in the under tray if its solid i.e. not fiberglass and filler under thick paint. I might also be interested in the two over riders with rubbers if you could send me a few better pictures to my email Richard@Bodytektaunton.co.uk

Many thanks Richard

you have PM

bump with reduced prices