Page 1 of 1
Do I need new UJ
Posted: Mon Aug 26, 2024 3:12 pm
by neilbardsley
I took the drive shaft UJ apart to clean and regrease. It wasn't moving as easy as I hoped. Seemed to be getting stuck in some positions. I found the inside of the casing had some groves in it. Time for a new UJ? What do you think?
Sent from my 22011119UY using Tapatalk
Re: Do I need new UJ
Posted: Mon Aug 26, 2024 3:21 pm
by neilbardsley
I hope the answer is no £135 each for the 33 teeth ones. Which I have
https://www.joeanselmomotorsports.com/p ... 6-33-teeth
Sent from my 22011119UY using Tapatalk
Re: Do I need new UJ
Posted: Mon Aug 26, 2024 4:24 pm
by anka
I had the same problem with mine, I decided to replace both side complete driveshaft.
It was a good decision.
Skickat från min iPhone med Tapatalk
Re: Do I need new UJ
Posted: Tue Aug 27, 2024 9:08 am
by Bruce M
The 33 spline CVs are a standard size (unlike the original 25). Although I think the hole for the dowel pin is larger than the bolt holes unless it uses a stepped dowel?
