Page 1 of 1
Trailing arm bushing
Posted: Tue Nov 24, 2020 4:28 pm
by desert rat
Need some help. Bushings for the trailing arm to chassis arrived today but they're too big. They're Rennlist and advertised as 65 to 89. My car is a 1970 911e the trailing arm is 30mm the bushings sent are 34mm. Any help would be appreciated.
Regards Stefan
Re: Trailing arm bushing
Posted: Tue Nov 24, 2020 5:02 pm
by fcd911
Hi Stefan
I have a set of genuine Porsche Trailing Arm Bushes (901 331 059 00) waiting to be fitted on '73 Steel Trailing Arms (still on car) – I have just measured them and they are also 34mm.
As an aside. I also tried to order new Trailing Arm Bolts and Nuts from the OPC but was told these are NLA!!
John
Re: Trailing arm bushing
Posted: Tue Nov 24, 2020 6:40 pm
by desert rat
After looking more closely and scraping away the powder coating looks like the old outer sleeves are still in. Going to be fun to get out . Came out easier than I thought they would!
Re: Trailing arm bushing
Posted: Fri Nov 27, 2020 9:45 pm
by alanjf
Hi Stefan, there is a special tool to remove the inserts, otherwise they can be a pain. You can carefully saw them which allows them to loosen up.
I installed the elephant racing bushes and had to take the arms and bushes to a friend with a press.
Alan
Re: Trailing arm bushing
Posted: Sat Nov 28, 2020 10:27 am
by Hannibales
Hi Stefan,
I replaced mine with the elephant racing trailing arm bushes...overnight in the freezer and they went in smoothly with a little easing from a vice.
At the same time I fitted the Wevo E-Z Pins to allow suspension removal/installation without taking out the transmission. Expensive for what they are, but made it an easy job and saved me a lot of time, which you can't buy more of!
As Alan said, the old bushing inserts can be gently cut with a hacksaw and then a cold chisel or appropriate socket will pop them out nicely.
Re: Trailing arm bushing
Posted: Sun Nov 29, 2020 9:52 pm
by alanjf
Hi Oli,
I had not heard about the Wevo E-Z Pins. Next time I know, although I expect the Elephant Racing bushings to outlast me!
The old bushes on one side were gone, so alignment was impossible. Job done - thank you lockdown!
Alan
Re: Trailing arm bushing
Posted: Sun Nov 29, 2020 10:19 pm
by desert rat
Managed to get the bushes out OK.Fitted Rennline high density bushes to the upper trailing arms, Elephant Racing bushes to the spring plates and to the front drop links. The car is a 1970 RHD 911e and I'm doing a full restoration. The shell is with Steve KertI at Classic Fabrications and will need a lot of work. Thank you for all the advice,
Regards Stefan.