DDK - Die Deutschen Klassiker

As I may be swapping heads at some point, does anyone have a pair of 2..0-litre cylinder head shrouds (they have the spark plug hole on a different location to 1.7/1.8 tins) they wish to sell?
Not worried about paint condition, just not rusty or bent.

i have a few type 4 tins, i wasnt aware of the plugs being in different places unless they are 3 stud inlet verses 4 stud, got any pictures of the tins you have/ need

1.7 and 1.8 engines have the plugs going in from the top, the 2.0-litre 914 heads have the plugs going in from the side.

2.0-litre:


1.7/1.8:

KS wrote:1.7 and 1.8 engines have the plugs going in from the top, the 2.0-litre 914 heads have the plugs going in from the side.

2.0-litre:


1.7/1.8:

never knew that , as the tins look the same, its possible to drill new holes and weld the wrong ones, ill have a look what i have but pretty sure i dont have that type

Yes it is possible, but if I can find some 'correct' ones. I'd prefer to go that route.

KS wrote:Yes it is possible, but if I can find some 'correct' ones. I'd prefer to go that route.

unfortunately i dont have the kind you need

Thanks for looking.