Page 1 of 1
New Member - Aberdeen Scotland
Posted: Sat May 16, 2020 8:25 pm
by Chris_ABZ
Hello I just joined. Moved to back to Scotland after about 10 years out of the country. I came back with a small Porsche problem. Currently I have a '71T in Cali getting a new motor. It was highly original, but I can't leave things alone. Now a 3.8, 964 based motor has been built by TRE ... should be fun! Full suspension by Tarrett/RSR with 930 type brakes. Hope to ship her over in time for a few fall highland runs. Anyone for the NW500?
Chris
Re: New Member - Aberdeen Scotland
Posted: Sat May 16, 2020 11:15 pm
by Bootsy
Welcome Chris
Look forward To seeing your car - sounds great
Re: New Member - Aberdeen Scotland
Posted: Sun May 17, 2020 8:42 am
by Boydyrs
Welcome Chris.....lookin fwd to seeing car
Re: New Member - Aberdeen Scotland
Posted: Sun May 17, 2020 9:32 am
by abzadams
Welcome Chris, your car sounds like it will be fun!
New Member - Aberdeen Scotland
Posted: Sun May 17, 2020 12:15 pm
by hot66
Welcome Ddk . Sounds fun
NC500 ... my betting is it will be mayhem this year with Everyman and his dog talking about doing it , what with euro driving on hold
Re: New Member - Aberdeen Scotland
Posted: Sun May 17, 2020 2:33 pm
by bjmullan
Welcome and it would be great to see pictures!
Re: New Member - Aberdeen Scotland
Posted: Sun May 17, 2020 4:35 pm
by yoda
Hi Chris. Sounds like a fun car, lets see some pictures. NC500 is on my list but probably not this year!
Re: New Member - Aberdeen Scotland
Posted: Tue May 19, 2020 8:26 pm
by Chris_ABZ
Here is a picture from the 2018 Targa California. It was a great trip. I have since had the "comfort" pack removed and have a great suspension installed. The clutch did not survive the trip so an engine out service etc was carried out before the next year's Targa. After the 2019 event I decided to build a 2.8 SS on a 7R case. However that mushroomed and a 3.8 based on a 964 case is going into the stock little narrow body along with a nicely built 915 box.