Page 1 of 1
Zenith 40tin carb Question
Posted: Thu Aug 16, 2018 5:11 pm
by moriarty
When re-fitting the hexagonal main jet holders into the body of the carb does the cross drilled hole in the jet holder have to line up with the hole in the bottom of the float chamber?
Re: Zenith 40tin carb Question
Posted: Thu Aug 16, 2018 5:41 pm
by Gary71
Off the top of my head no. Any chance of a picture to remind me?
Re: Zenith 40tin carb Question
Posted: Fri Aug 17, 2018 12:28 pm
by moriarty
Re: Zenith 40tin carb Question
Posted: Fri Aug 17, 2018 12:56 pm
by Gary71
That’s the same as mine. It’s just luck of the draw if it lines up or not. There is clearance all the way around so it doesn’t matter.
Re: Zenith 40tin carb Question
Posted: Fri Aug 17, 2018 8:14 pm
by moriarty
OK Thanks Gary.
Cheers M
