DDK - Die Deutschen Klassiker

Can anyone offer me any advice about what these items are. I'm clearing out a few boxes of stuff which are mostly Porsche and a few VW parts. Just can't figure out what these 5 items are.
It's like a quiz !

top 2 are seatbelt receivers with the extension for sports seats i believe but missing the black plastic body parts and the red knob for the lever..

Pics five and six are of a 914 D-Jet ECU mount.
Pics seven and eight are of a piece of 914 lower engine tin.

Yea, 7&8 lower engine tin left hand side looking from the back of the car, the gear shift rod runs above the groove. Will not fit 1975 1.8 USA models.

The last 2 photos show 2 pairs of seatback 'stops' for std (ie non-Sport) seats - missing their rubber buffers.

3rd picture could be a clutch pedal stop plate (bolts to wooden pedal board) but doesn't look exactly like the 911 ones I've had so could be 914 (or later 911) ?

If only you had had the rubber bump stops on the seat parts Andrew. Why are they always missing?
Been searching for four for four years or more.

Regards
Mike

You should have said Mike - I sold these last year:

I think I have some of them, I'll have to check. I didn't know what they were either.

210bhp wrote:If only you had had the rubber bump stops on the seat parts Andrew. Why are they always missing?
Been searching for four for four years or more.

Regards
Mike

Thanks Andy, can see what you mean now. As you say 911/912 one is smaller. Think the 914 one is the same so not sure what this one is. Maybe VW something ????

Lightweight_911 wrote:The last 2 photos show 2 pairs of seatback 'stops' for std (ie non-Sport) seats - missing their rubber buffers.

3rd picture could be a clutch pedal stop plate (bolts to wooden pedal board) but doesn't look exactly like the 911 ones I've had so could be 914 (or later 911) ?

Many thanks Dougieboy1, Defianty and Green Ernie. I think that's a clean sweep now !
Just need to find out what model the clutch stop plate come from. Beetle ?? Karmann Ghia ?

defianty wrote:Pics five and six are of a 914 D-Jet ECU mount.
Pics seven and eight are of a piece of 914 lower engine tin.

Still haven't managed to figure out what item pictured on pictures 3/4 is. As Andy suggested looks like a pedal stop plate ut I haven't been able to figure out what it might be despite a load of searching on Google.
Anyone ?

Just found this as well. Any ideas what it is ? Looks like a very short speedo cable drive, but what from. It is 28.5cm long tip to tip and has YBD-10043 & 1B2 S.S. WHITE written on it.






Still trying to figure out what this is. Looks something like a clutch pedal stop mounting plate but no idea what model ?