Page 1 of 1
Cleaning Fuse Block
Posted: Sat Mar 25, 2017 12:07 pm
by BILLY BEAN
What is the best way to clean a fuse block especially the terminals?
Thanks for any advice.
Regards, Kirk
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 1:19 pm
by visualfx
Kirk,
I use these on the fuse terminals and things like bulb holders, works great on copper tabs also
http://www.ebay.co.uk/itm/Fibre-Fiber-F ... 3641.l6368
cheers
Garry
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 1:33 pm
by BILLY BEAN
Garry,
Thanks very much for the help.
Regards, Kirk.
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 3:00 pm
by Alan @ CanfordClassics
We take it out and use our vapour blaster on low pressure. They look like new after.
HTH
Alan
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 9:58 pm
by BILLY BEAN
Thanks Alan but I am going to rely on elbow grease in the absence of a vapour blaster.
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 11:15 pm
by Jonny Hart
You can also soak them in acid too. Alternatively, buy a a proper fuse panel from us.
Re: Cleaning Fuse Block
Posted: Sat Mar 25, 2017 11:18 pm
by aston
I used a Dremel with a small wire brush attachment.
Re: Cleaning Fuse Block
Posted: Sun Mar 26, 2017 9:23 am
by Alan @ CanfordClassics
If you get stuck Billy just send it down or if passing you are welcome to borrow it.
Alan
Re: Cleaning Fuse Block
Posted: Sun Mar 26, 2017 8:00 pm
by BILLY BEAN
Thanks to every one who took the trouble to respond. Fuse blocks now cleaned.
Jonny nice try at a sale of your new fangled fuse blocks. Thanks but no thanks.
Regards.