DDK - Die Deutschen Klassiker

Hi all

I'm quite new to the 912 and older Porsche scene in general, just wondering who can supply the metals, such as panels floors etc etc that do rust, also my current parts are only a bit rusty but they are original, so what is the consensus here, do you guys recommend to repair or replace, as right now the lines etc are perfect. The paint is Original but very faded so I'm going to get a blow over just to get the shine back, if you haven't read my other thread the car is a 1968 912

Thanks !

Rogerbray has almost everything

Sent from my MotoE2(4G-LTE) using Tapatalk

Some photos would be good
Would help people give more accurate answer to some of your questions.
Where are you based?

Thanks guys, i have been on Rogers site but it was not loading up on my phone properly, will check again at home, once I have some time I'm going to get the car up
In the air and have a proper look around, see exactly what I need !

Also I'm based in west London near Chiswick

Porsche themselves still supply panels. Expensive at times but they fit better than any of the pattern panels I have bought. Next would be restoration design who make their own in Canada with a European base.

About ninth on the list would be Dansk panels and only if I really had to.

HTH

Sean

Thanks guys valuable info

Is there a diff in the panels between 911 and 912 of the same year? And also do the diff wheelbases also have differences in panels?

Mr912 wrote:Also I'm based in west London near Chiswick

Well you are nicely located for two 911/912 experts.

Chris Turner has his garage in NW10 and is on here as butzi. He has been working on these cars since the 70s. Chris organises a DDK get together in SW London. I think it's the 3rd Wednesday in the month. Have a look in the events section.

Also Max at Revival Car is focused on 912. He is based at Terminal 5.

Thanks that's ideal info, and I'm usually around the Heathrow area !