Page 1 of 1
Anyone have a pic of all the tinware for a 912 laid out ?
Posted: Thu Jun 16, 2016 7:21 pm
by In2Rust
My 912 motor is missing a load of the tinware.
Has anyone got a pic of all the tinware laid out. So I can work out which bits I need to get.
thanks in advance
Re: Anyone have a pic of all the tinware for a 912 laid out
Posted: Fri Jun 17, 2016 4:23 pm
by Ollie
Re: Anyone have a pic of all the tinware for a 912 laid out
Posted: Fri Jun 17, 2016 10:59 pm
by David Rooke
I doubt this adds much to the above diagram but here is what I sent off for powder coating - omitted are the heat deflector shields near the cylinder heads and the lower fuel pump piece...
Re: Anyone have a pic of all the tinware for a 912 laid out
Posted: Fri Jun 17, 2016 11:47 pm
by C3s
Good luck, still trying to fathom my lot out
Re: Anyone have a pic of all the tinware for a 912 laid out
Posted: Mon Jun 20, 2016 12:47 pm
by neilbardsley
Not many cars have piece 12 on them.
Re: Anyone have a pic of all the tinware for a 912 laid out
Posted: Mon Jun 20, 2016 4:11 pm
by Black66
neilbardsley wrote:Not many cars have piece 12 on them.
What do they have for heating then ?
And do many 912's have the thermostat and linkage (15 to 21) or is that a 356 thing ?
