Page 1 of 1

polishing and painting fuch6s

Posted: Fri Mar 23, 2012 10:08 pm
by Beetlejac
Hi this is how l polished and painted my Fuchs
Image
after going up the grades in wet and dry l polished with cloth buffs and wax.
Image
l masked the wheels off from the back
Image
Image
Image
l then welded up a frame to sit the wheel on flat and square
Image
Image
l then filled the wheel with paint up to the edge of the rim
Image
Image
Image
l let it sit for about an hour,punched a hole in the masking tape and let th6e paint drain off to re use on the next wheel.
Image
Image

Re: polishing and painting fuch6s

Posted: Sun Feb 12, 2017 9:59 pm
by Beetlejac
what sort of cash is in these wheels?

Re: polishing and painting fuch6s

Posted: Sun Feb 12, 2017 10:25 pm
by majordad
Not much, they're hooker shiny !

Re: polishing and painting fuch6s

Posted: Mon Feb 13, 2017 2:53 pm
by Beetlejac
Good,l weighed them in for scrap anyway.

Re: polishing and painting fuch6s

Posted: Mon Feb 13, 2017 3:05 pm
by Sam
Americans like shiny wheels, advertise them over there.

This side of the Atlantic everyone will budget to strip them, anodise them and fully paint the centres satin.

Either way 8s are worth plenty so go and fish them out of the bin.

Re: polishing and painting fuch6s

Posted: Thu Feb 23, 2017 11:18 pm
by Loz
It's quite a good idea not to paint where the wheel bolt seats.
When the paint cracks and falls out, it leaves the wheel bolt loose.

Hth