Page 1 of 1
Any sparkies out there?
Posted: Thu Jun 24, 2010 5:50 pm
by bonerp
Hi
I have bought a pair of electric hairdryers - both 150w for the screen demister.
Can anyone suggest what relay I would need to cover this power and cable sizes? There seems to be a couple of kits on ebay that might do.
If I have to make it up, I understand pins 85 and 86 are to the switch and 30 is +12v (switched?) and 87 earth?
Guess I will have to be careful with the switch too? Was going to use a lucas type pull switch.
thanks in advance
Paul
Posted: Thu Jun 24, 2010 6:57 pm
by impmad2000
This may help
http://www.bcae1.com/relays.htm
Gnd pin 86, connect 85 via a switch (only a few mA so low current switch will do) This will operate the relay.
Connect the 12V via a fuse to pin 30. and the two heaters (In parallel) to pin 87.
GND the other side of the heaters.
The heaters are 150W, so at 12V thats 12.5A (I assume that's each)
If the relay is running both, then a 30A relay will be fine.
There's a wire rating chart here
http://www.constructorscarclub.org.nz/A ... part5.html
Tim
Posted: Thu Jun 24, 2010 7:34 pm
by bonerp
thanks heaps Tim - very kind
Wiring brake test switch
Posted: Tue Jun 29, 2010 3:49 pm
by bonerp
Hi
I have bought an 'sva' ok brake resvervoir with a built in switch - then read somewhere that it needs to be testable from the dash! Doh. Any ideas how this should be wired as currently I don't have this in the loom - the loom is about 6 years old - older thank IVA!
thanks
Paul
Posted: Tue Jun 29, 2010 4:47 pm
by impmad2000
Sorry, don't know what the requirement is for this one.
Tim
Posted: Sun Jul 04, 2010 9:15 am
by mdmax72
Hi paul,
i've got the switch you need and wiring etc, give me a call 07721688475 May have a few more bits for the IVA for you.
Regards Rich
Posted: Tue Jul 06, 2010 7:46 pm
by bonerp
Hi Rich
I've tried to call a couple of times - drop me an email on
bonerp@hotmail.co.uk when you have a moment.
thanks
Paul
Posted: Mon Jul 12, 2010 3:05 am
by ger
What you do is to double up the fluid warning light and the handbrake warning light. So, handbrake on and the dashlight is on, proving that its workin !
Posted: Thu Jul 22, 2010 8:14 pm
by bonerp
Haven't got a switch on the handbrake - how/have you fitted one gerry? I've got a momentary switch for the dash and will wire this in parallel to the reservoir switch.
Posted: Thu Jul 22, 2010 10:26 pm
by ger
I got a vw switch from the scrappies, old golf if I recall correctly, most any will do, I then welded on a wee tab to the handbrake to operate it.
It will all be hidden under the hb gaitor
I'll get some pics tomorrow