Drive shaft question
Moderators: drummerboytom, MdR
-
- DDK addict
- Posts: 140
- Joined: Sat Aug 15, 2009 8:32 pm
- Location: a part of london usually on fire
Drive shaft question
Anyone know the name and size of the tool needed to undo the driveshaft CV bolts. Mine are full of crap, but want to order the tool prior to cleaning them... are they 6 or 12 spline or something else?
-
- DDK 1st, 2nd and 3rd for me!
- Posts: 2069
- Joined: Wed Jun 23, 2004 9:47 pm
- Location: Nottinghamshire
You need a 12 spline 8mm tool for 914 splined bolts (though some might have straight 8mm allen heads if they have been replaced with non OE ones).
Regards
Wayne
Regards
Wayne
93 964 C2
99 Boxster 2.5 > 2.7 hill climber
71 914/6 3.0 - gone
'You see Paul, hill climbing is like making love to a beautiful woman. You get your motor running, check your fluids, hang on tight and WHOA..30 seconds later it's all over!' Swiss Tony
99 Boxster 2.5 > 2.7 hill climber
71 914/6 3.0 - gone
'You see Paul, hill climbing is like making love to a beautiful woman. You get your motor running, check your fluids, hang on tight and WHOA..30 seconds later it's all over!' Swiss Tony
-
- DDK addict
- Posts: 140
- Joined: Sat Aug 15, 2009 8:32 pm
- Location: a part of london usually on fire
Drive Shaft Question
I bought mine from the local snap-on van, as already mentioned I had a mix of the OE & Allen headed bolts. Be careful to use the correct tool or else you can round off the OE ones..... It's worth replacing any damaged ones.
Phil w
Phil w
-
- DDK addict
- Posts: 140
- Joined: Sat Aug 15, 2009 8:32 pm
- Location: a part of london usually on fire