Page 1 of 1

A little help needed

Posted: Sun Oct 18, 2009 12:30 am
by TheBaron
I need some help in return for as much tea and biscuits you can eat plus any out of pocket expenses.

I have just had my new Super 90 engine installed in the ACE, Andy Prill built it up, I have been using a loan engine from Roger Bray who did the actual body restoration.

Andy is in Mexico racing, and Roger is to far to get to, so Andy has given me running instructions for the first 1000 miles.

After the first 100 miles i need to change the oil, (not a problem I think) and adjust the valve clearances which were set 0.1 out to allow bedding in.

As i have not done this before i dont feel happy tackling this on my own, once i have seen it done I will be confident doing it on my own.

So if anyone lives near me, I can either come to you, or you could come to me and if I could just watch what is involved, the next time I will be happy to have a go myself.

I live nr Marlborough Wiltshire.

Any offers of help will be greatly appreciated.

Regards

Stephen

Posted: Mon Oct 19, 2009 9:22 am
by louis356
Hi, Would love to help out, or even watch myself but you are just a little too far. I have some DVDs from 'the Maestro' that I can send for help as he demonstrates this stuff. might help

PM me your address and I'll try and get it done ASAP.

Posted: Mon Oct 19, 2009 4:13 pm
by Hendrik Moulds
Would love to come and do it, but it's a bit far from me too.
It is quite easy to do though.