DDK - Die Deutschen Klassiker

Hi all, I just tried to replace my indicator switch but found that the wire diagram I have is not correct.


I have a red wire and a white with black strip and a white with red strip left over.

The diagram lists these as white.

How do they connect?

I also have a red with white strip wire from the main loom left over.

I dont want to assume the old switch was connected correctly.

Can any one help. Car is a 1960 B t-5 RHD.

as in the stalk on the steering column?

it should give a left flash, right flash and in/out (high/lowbeam) ?

I thinks..............
Not sure about the foot switch to do the high/lo beam though ?

Are the wires coming off the new switch, or needing to go to?
d

Yes the turn signal switch stalk thing.

What foot switch? My B t-5 dont have a foot switch.

The red, white with red an white with black are coming off the switch.

The red with white is part of the main loom.

Hi,
My car is RHD JANUARY 1960 T5 and is wired as follows

SWITCH LOOM
brown === brown
black/thick green === black/thick green
black/red === black/red
black/white === black/white
black/purple === black/purple
black/thin green === black/thin green
black/yellow === black/yellow

WHITE/RED === RED/WHITE
YELLOW === YELLOW

hope this helps.if i can help with aything else please ask