WTB 2 rocker arms
Posted: Tue Mar 04, 2008 8:24 pm
Fitting RSR rocker arm seals to my 2.2 'E' engine that was upgraded to 2.2 'S'.
Was rebuilt 10K miles ago by previous owner. Did cyls 1.2.3. - very impressed by the fact that there were no signs of wear whatsoever on the cams and follower part of the rockers. Just the nice even linear polishing you get. Well pleased. Tied the left hand side up and started on no 4 cyl.
Cam lobe again unmarked but the follower part of the rocker that runs against it has devloped a small crater. Need to replace it before it picks up and marks my otherwise spotless and valuable 'S' cam lobe. So does anybody have a spare 'E'/'S' spec inlet rocker arm to sell please? There is no part number on it so I assume it is the same arm for inlet as exhaust, not sure if it is the same as the 2.2 'T' arm. Needs to have the phosphor - bronze bush in tact too and the foot/follower needs to be unmarked except for the usual polishing. Would take 2 to keep 1 as a spare if I find another culprit. If there is anybody out there would be pleased to hear.....
Was rebuilt 10K miles ago by previous owner. Did cyls 1.2.3. - very impressed by the fact that there were no signs of wear whatsoever on the cams and follower part of the rockers. Just the nice even linear polishing you get. Well pleased. Tied the left hand side up and started on no 4 cyl.
Cam lobe again unmarked but the follower part of the rocker that runs against it has devloped a small crater. Need to replace it before it picks up and marks my otherwise spotless and valuable 'S' cam lobe. So does anybody have a spare 'E'/'S' spec inlet rocker arm to sell please? There is no part number on it so I assume it is the same arm for inlet as exhaust, not sure if it is the same as the 2.2 'T' arm. Needs to have the phosphor - bronze bush in tact too and the foot/follower needs to be unmarked except for the usual polishing. Would take 2 to keep 1 as a spare if I find another culprit. If there is anybody out there would be pleased to hear.....