Clips for oil pipe
Posted: Wed Feb 06, 2008 3:25 pm
Hope Gary doesnt mind me "borrowing" a pic of his engine but does anyone have the clips arrowed?
Don't know if these will be any good but I got mine here
P-clips
DDK - Die Deutschen Klassiker
The 'Maverick' Classic Porsche Forum and Classic Porsche Club for Porsche 356, Aircooled Porsche 911, Porsche 912, Porsche 914 & Porsche Replicas. 'We join for the cars but stay for the people'
https://www.ddk-online.com/phpBB2/
Clips for oil pipe
Page 1 of 1
Posted: Wed Feb 06, 2008 3:51 pm
Posted: Wed Feb 06, 2008 4:43 pm
You have pm 
Careful not to position the oil pipe like this. It all looks neat and I wanted to hold it off the top of the gearbox, but I had to remove the clips once I tried to get the engine in as it trapped it neatly against the body
Careful not to position the oil pipe like this. It all looks neat and I wanted to hold it off the top of the gearbox, but I had to remove the clips once I tried to get the engine in as it trapped it neatly against the body
Posted: Wed Feb 06, 2008 5:08 pm
Thanks chaps
Any ideas where the pipe should be placed? as I also thought it might foul the bodywork being routed across the bellhousing, Gary is yours not attached now?
Any ideas where the pipe should be placed? as I also thought it might foul the bodywork being routed across the bellhousing, Gary is yours not attached now?
Posted: Wed Feb 06, 2008 5:23 pm
Underneath, rather than over the top.
Bob
Bob
Posted: Wed Feb 06, 2008 5:30 pm
Hi James/Gary
I am no expert BUT I know a man who is....these 2 photos show where the 2 clips go sorry about the poor quality its the only one I have.
This clip is mounted on the diff cover nuts.
Kind regards
I am no expert BUT I know a man who is....these 2 photos show where the 2 clips go sorry about the poor quality its the only one I have.
This clip is mounted on the diff cover nuts.
Kind regards
Posted: Wed Feb 06, 2008 5:32 pm
I hope Brendan catches this thread
You there Brendan?
Regards
Mike
You there Brendan?
Regards
Mike
Posted: Wed Feb 06, 2008 6:04 pm
Mine is now lower down like the pictures above. Still clipped in place though.
Posted: Wed Feb 06, 2008 6:33 pm
Excellent,
thanks for the photos John, now what are the details on that engine? is that a valve cover on the TBs??
thanks for the photos John, now what are the details on that engine? is that a valve cover on the TBs??
Posted: Wed Feb 06, 2008 6:47 pm
Or slidevalve?Mmmmmmmmmm58A - 71E wrote:Excellent,
thanks for the photos John, now what are the details on that engine? is that a valve cover on the TBs??
Posted: Wed Feb 06, 2008 7:41 pm
What slide throttle 
Posted: Fri Feb 08, 2008 7:08 am
They just look very similar to slides from that angle:
What setup is it?
What setup is it?
Posted: Fri Feb 08, 2008 10:49 am
I will have to remember that position when I redo my oil lines