Page 1 of 1
bits
Posted: Fri Dec 07, 2007 3:29 am
by pantswagen
930 for re build -chop in £160
type 4 van stock length performance doings - will swap for some shorty ones or £80
one as new 964 front disc -bought in error -cheaper than new££££ - or wapsies
pair of them there 965 disceroonies, skimmed from 32 to about 30 £100
centremount doings £20
csp pulley £30?
-4 44mm alloy trumperts £25??
swapsies
a better pic of those dooberies - i buyed them thinking i could cut them, -but i cant - will fit a 92 i think - i dunno though
will swap for some short ones
set of mint refurberished cup 2's 17's both 55et -will swapsies the rears for them helucyve 70 et;s
Bits
Posted: Mon Dec 10, 2007 1:49 pm
by hughicol
Hi
The photo before the wheels seems to be a silencer but there is no reference to it. What vehicle is it for?
Dave
Posted: Mon Dec 10, 2007 2:32 pm
by Nige
looks like a twin quiet pack for a type IV, Bus maybe?
Bits
Posted: Mon Dec 10, 2007 2:35 pm
by hughicol
Hi Nige
Was hoping it may be for a 914
Dave
Posted: Mon Dec 10, 2007 3:05 pm
by Nige
I'm sure with abit of jiggery pokery it could be made to fit, the J tubes are for a van says higher in the thread, they will be too short for a 914.
Bits
Posted: Mon Dec 10, 2007 3:15 pm
by hughicol
Hi Nige
But the distance between the inlets to the silencers are different.
Dave
Re: Bits
Posted: Mon Dec 10, 2007 3:21 pm
by swapped
hughicol wrote:But the distance between the inlets to the silencers are different.
Not by much, though.
It'll fit if you want it to.
Posted: Mon Dec 10, 2007 4:51 pm
by 912uk
interested in the 4 44mm trumpets.
can you tell me the pcd of the two holes..?
typically
Posted: Mon Dec 10, 2007 11:42 pm
by pantswagen
typically, i go and get some csp inlets at 55
-get the trumpets at 44mm
-decide i only want 40's
-then some 44's come up 4 sale
-hold fire for a ickle bit
-ps tehy are idf dell ones, well i think so
Posted: Tue Dec 11, 2007 11:46 am
by Dyno Soar
Is that pulley wheel for a T4 engine?
Will it fit onto a web cam?
Thanks
Posted: Tue Dec 11, 2007 11:59 am
by Nige
looks type iv to me Alam, three mounting holes, type i are just one big bolt. Why does it need to fit to a web cam? They are usually fitted to the crankshaft. Or do you intend to fit a webcam onto it for those dodgy internet performances you do?
Bits
Posted: Tue Dec 11, 2007 12:02 pm
by hughicol
The centre hole looks rather big on the picture.
Dave
itssss
Posted: Tue Dec 11, 2007 11:06 pm
by pantswagen
its because its type 1 sized
-ie to be used on a type 4 with a dtm
-or cali doobery
